750 Taillights
Print Instructions
Bad Dad's 750 Taillights are a great looking LED taillight options that is easy to install. These lights can be installed in clusters of 6, 8, or 10 lights. These lights include a basic plug-n-play wiring harness for easily installing and routing all your wiring. Below is the step-by-step instructions for this install. |
Here you can see the six (6) pre-wired LED with their billet housings, wiring connectors, wiring harness, and templates. You will need a drill, 1/2" drill bit, and tape measure (not included) for this install.
Choose the spacing you prefer and place the template on the fender. We recommend using a tape measure to make sure your templates are placed evenly on your panel.
Note: Drill the same number of holes for which you have LEDs. Some of the templates include markings for four holes. Do not drill four holes if you do not intend to install four lights.
The wires are pre-pinned for you so you only need to snap the wires into the housing. Match up the wiring colors (black to black and red to red) going into the housing with the wiring colors in the main section of the harness.
The included wiring harness layout allows you to neatly tuck all this wiring behind your panel with the included quick disconnect housings.