Custom Motorcycle License Plate Install
It is time to install your custom license plate now that you have installed your flush mount license plate lens. The following instructions are the steps taken by the Bad Dad staff when installing custom plate setups in our fenders.
 |
| 1.
This is the fiberglass pocket that will hold the license plate.
|
 |
| 2.
Backside of fiberglass pocket.
|
 |
| 3.
Start by trimming outside of pocket so that it snuggly fits the
backside of your fender cover.
|
 |
| 4.
Using the corner mounting holes of your plate, mark the four corners
with a pen or marker to indicate where you will mount your LED plate
studs.
|
 |
| 5.
Use a drill bit to drill the holes for your LED studs.
|
 |
| 6.
These are the four LED plate studs you will use to anchor the
license plate to the fiberglass pocket.
|
 |
| 7.
Once the plate is anchored, aim the four lights toward the center of
your plate and then tighten the studs with the supplied allen
wrench.
|
 |
| 8.
Backside of trimmed pocket with studs installed.
|
 |
| 9.
License plate illuminated during daytime/normal outside lighting
conditions.
|
 |
| 10.
License plate illuminated during nighttime/dark lighting conditions.
|
 |
11. Finish be spread a layer of silicone around the outside of the pocket to keep the inside of the plate pocket weather-tight. When changing your yearly tag, simply cut the silicone with a knife, remove the strap, change tag, re-install strap, and add new silicone. (Note the studs used for securing the steel strap pictured in the next step, step 12.)
|
 |
| 12.
Finish by mounting the license plate to the back of the fender using
a steel strap or other mounting device.
|
|
Related Bikes: |
Related Instructions: |
Related Links: | ||||||
|
Bad Dad Custom Motorcycle Finishes
260-407-2000 l hinseys@msn.com
| Locate Us |
A Division of Hinsey's Pro Paint, Inc.