Bill's Bags Project

Part I: Body work and light install

 

With the custom lenses cut and machined, the light clusters built and set into place, this sub-assembly has now been installed and body worked into the new bags.    

 

Lens machined		Lenses
Lights fit	Backside	Light lit
Final wiring		Silicone for weather protection
	Outside strips- run and brake; Middle strip- sequencing turn signal
Run lights		Run lights up close
Because Bill's RG uses a side exit exhaust, these one piece bags are boxed in in the rear for more storage over the other one piece bags
Gel coat		Gel coat

 

The Build:	The Video:
Second Step: Paint Vivid Black Third Step: Final clear coat	Click here to see a video of Bill's Bags

 

Bad Dad Custom Motorcycle Finishes

---