Bad Dad Rear Fender Install

 

Top mounting

The Bad Dad fender installs easily over your factory fender in three areas.

 

(1) Attach at the wire loom studs by drilling through the Bad Dad fender, then running a fender washer and nut over the stud.

 

(2) Using the indicated raised area on the Bad Dad fender, drill your seat bolt hole.  Secure the fender with your factory bolt.

Bottom mounting

(3) Attach at the bottom of the fender. 

 

This can be done by:

 

(a) Running a screw or bolt through the Bad Dad fender and into the factory fender.  Finish by mounting your taillight over the screw or bolt;

 

or

 

(b) Matting a stud into the bottom of the Bad Dad fender. Finish by securing the stud through the factory bumper bracket stud, as pictured at left.